Table of Contents
Advertisement
INStAllAtION
1
Threaded rod
2
Nut
3
Washer
9
The support rods must be attached to structures able to
support the weight of the unit.
9
If the unit is not perfectly horizontal, water leaks may occur.
9
Ensure that the ceiling section does not include pipes or
electric lines.
9
Check that the installation is horizontal using a water level.
Drilling into the wall:
1
A
A
Inner side
B
Outer side
1
Plastic tube
— drill the through hole into the wall
— keep a downward inclination toward the external side
— insert a plastic tube in the hole in order to protect the con-
nections
— seal with stucco
9
Ensure that the ceiling section does not include pipes or
electric lines.
1
M10
2
3
5 - 6 mm
B
10
2.10 Aeraulic links
Preliminary instructions
9
The dimensions of the channels and the inlet and outlet grids
must be determined by a professional, skilled operator.
9
To avoid the transfer of the machine's vibrations to the environ-
ment, it is suggested that an antivibrating joint be positioned
between the ventilating outlets and the channels.
9
Use a channel sheathed with an appropriate thickness of an-
ti-condensation material.
9
Apply a thermal insulation on the joints.
9
Practice an opening in the channels, to enable filter removal.
9
The connection tubes must have the appropriate diameter and
must be supported, so as not to rest their weight on the unit.
Connection
— Position the channels in conjunction with the connectors on
the unit.
— Fasten using screws of the appropriate dimensions for the
precut holes.
9
Connect the fan motor according to the length of the delivery
duct:
— <0.5 m use the white connector (default)
— 0.5 m <length delivery <2m use the red connector
1
3
4
8
1
Delivery duct
2
Recovery duct
3
Support pipe
4
Recovery feed opening
5
Circular attacks delivery
plenum
2
5 6
7
9
6
Delivery duct
7
Delivery feed opening
8
Delivery screen
9
Recovery duct
Advertisement
Table of Contents
