Sony BPU4800 Operating Instructions Manual page 21

Page name Item
Page No.
<RETURN> SDI1
C06
SDI2
FRAME SYNCHRO
HD PROMPTER
<IP ADDRESS IP ADDRESS
SETTINGS>
SUBNET MASK
C07
DEFAULT GATEWAY
SET
MAC ADDRESS
<CNS SETTINGS> CNS MODE
C08
SET
(Not available when a
CCU is connected.)
<TRANSMIT> CCU TRANSMIT
C09
<OTHERS> ASSIGNABLE
SWITCH
C10
HD DOWNCONV
FILTER
CHARACTER LEVEL
CONTROL CSA
MENU
CLEAR BPU
SETTINGS
<OPTION KEY> READ (USBtCAM)
C11
INSTALLED OPTION
<HFR PAINT OFFSET> DETAIL LEVEL
C12
DETAIL CRISP
Set value
1080/59.94i(PsF), 1080/59.94P,
1080/50i(PsF), 1080/50P,
NO SIGNAL, ---
1080/59.94i(PsF), 1080/59.94P,
1080/50i(PsF), 1080/50P,
NO SIGNAL, ---, HD PROMPTER
OFF, ON, ---
OFF, ON, ---
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
ENTER to execute
00:00:00:00:00:00 to
FF:FF:FF:FF:FF:FF
LEGACY, BRIDGE
ENTER to execute
HIGH BIT RATE, HD-SDI
OFF, BPU BARS
1 to 4, 0.3, 0.6
1 to 5
ENTER to execute
ENTER to execute
ENTER to execute
–99 to 99, 0
–99 to 99, 0
21
Meaning
Format of video signal input on SDI1 connector
(display only)
---: When a CCU is connected
Available only for extension connection.
Format of video signal input on SDI2 connector
(display only)
---: When a CCU is connected
HD PROMPTER: HD prompter is on.
Available only for extension connection.
Return signal frame synchronizer on/off setting
HD prompter on/off setting
Available only for extension connection.
IP address setting
Subnet mask setting
Gateway IP address setting
MAC address of the unit (display only)
Communications mode setting
Sets the type of CCU connected.
HIGH BIT RATE: CCU that support high bit rate.
HD-SDI: CCU that does not support high bit rate.
CCUs with 1.5 Gbps optical transmission are not
supported.
Assignable button function select
4K video signal to HD signal down-converter filter
type
Menu character contrast level
Reset to factory default settings (not executed when
using HD Cut Out in the web menu)
Read the install key from a USB flash drive.
List of installed options (display only)
Sets the offset amount of DETAIL LEVEL to be added
to HFR video.
DETAIL LEVEL is the standard for normal speed that
is set from the MSU/RCP. 0 is the same as normal
speed.
Sets the offset amount of DETAIL CRISP to be added
to HFR video.
DETAIL CRISP is the standard for normal speed that
is set from the MSU/RCP. 0 is the same as normal
speed.