Chapter 8 Transmitter Operation; Record The Process Variables; View Process Variables - Emerson Micro Motion 9739 MVD Configuration And Use Manual

Chapter 8
Transmitter operation
Topics covered in this chapter:

♦ Record the process variables

♦ View process variables

♦ View transmitter status
♦ View and acknowledge status alarms
♦ Start and stop totalizers and inventories
♦ Reset mass and volume totalizers
♦ Reset mass and volume inventories using ProLink II
8.1 Record the process variables
Micro Motion suggests that you make a record of specific process variable measurements, including
the acceptable range of measurements, under normal operating conditions. Making a record of the
variable measurements will help you recognize when the process variables are unusually high or low,
and may help you better diagnose and troubleshoot application issues.
Procedure
Record the following process variables, under normal operating conditions:
Process variable
Flow rate
Density
Temperature
Tube frequency
Pickoff voltage
Drive gain
8.2 View process variables
Display Scroll to the desired process variable, or if AutoScroll is enabled, you can wait until the process variable is
displayed.
ProLink II ProLink→Process Variables
Field Communicator Overview→Shortcuts→Variables→Process Variables
Configuration and Use Manual
Typical
Measurement
Typical high Typical low
155