IBM Aptiva Hardware Maintenance Manual page 81

•
Diskette drive should be connected to the system board connector
CN16 (see "2137 System Board "on page 5-5) or CN19 (see "2138
System Board Layout" on page 5-15).
•
IDE Primary Channel Master and Slave Drives in BIOS Setup
should be connected to the system board connector CN13(see
"2137 System Board "on page 5-5) or CN9 (see "2138 System
Board Layout" on page 5-15).
•
IDE Secondary Channel Master and Slave Drives in BIOS Setup
should be connected to the system board connector CN10(see
"2137 System Board "on page 5-5) or CN8 (see "2138 System
Board Layout" on page 5-15).
NOTE: The CD-ROM drive comes with system unit should be configured
as IDE Secondary Channel Slave device.
−
Check the hard disk and CD-ROM drives jumper settings. See "3.5-
In. Hard Disk Drive Jumper Locations" on page 5-21 or "5.25-In.
Hard Disk Drive Jumper Location" on page 5-24 and "CD-ROM
Drive" on page 2-34.
−
Check the voltages of all disk drive power connectors. See "Power
Supply Cable Connector Specifications" on page 5-18.
−
Correct the parameter settings under Disk Drives in the BIOS
Setup. See "Disk Drives" on page 1-21.
−
In the BIOS Setup, check that the correct drive size is set for the
flagged drive shown in the Installed Devices list.
−
If the problem remains, check the continuity on the drive and the
cable and replace it if necessary. If that does not fix the problem,
replace the system board.
−
End.
005 –
−
Select Diagnostics from the PC-Doctor diagnostics program main
menu. Select and execute Floppy Disk Test if you want to test
diskette drive. Select and execute Hard Disk Test if you want to
test hard disk drive.
−
Select Interactive Tests from the PC-Doctor diagnostics program
main menu, then select and execute CD-ROM/DVD Test if you
want to test CD-ROM drive.
−
If the diagnostics program did not detect a failure, but the system
still displays a failure:
2-28