Table of Contents
Advertisement
Installing the Handsfree Kit
Guidelines for Installation and Connection
• Only qualified personnel should install this car kit. If necessary, contact with
vehicle manufacturer for air bag information specific to the vehicle.
Caution: An air bag inflates with great force. DO NOT place objects, including
communication equipment, in the area over the air bag or in the air bag deployment
area. If the communication equipment is improperly installed and the air bag
inflates, serious injury could occur.
• Mount components securely on strong surfaces to prevent shifting that could
cause injury or interfere with safe vehicle operation. Always use the supplied
mounting hardware
• Mounted components and attached wires or cables must not interfere with
seating or leg space.
• Route cables so they are protected from pinching, sharp edges, and crushing.
Keep all in-line connectors easily accessible.
• This car kit is intended for use in 12 volt negative ground systems only. The car
kit draws less than 5 amps. Confirm that the vehicle's electrical system can
supply this current.
How to Install the Handsfree Kit
Caution: This car kit must be connected to a 5A fuse in the car fuse panel to
prevent fire or other damages if a short circuit should occur somewhere in the
electronic module. Before installing the car kit, disconnect the vehicle's battery.
Before you begin: Unpack, assemble, and test all components on a service bench.
Car Kit Contents
Interface Cable
The Interface Cable connects the electronic module to the other system
components. It connects the vehicle's power and ignition to the car kit and provides
some optional audio connections when the car kit is used with the vehicle's radio.
Electronic Module
You can place the electronic module anywhere inside the vehicle to facilitate
convenient connection between the interface cable and other system components.
6
Advertisement
Table of Contents
