Installing The Hands-Free Car Kit; Guidelines For Installation And Connection; Installation Procedure - Motorola WIRELESS BLUETOOTH CAR KIT CH1324A Manual

Installing the Hands-free Car Kit

Guidelines for installation and connection

Only qualified personnel should install this car kit. If necessary, contact with vehicle
manufacturer for air bag information specific to the vehicle.
Caution: An air bag inflates with great force. DO NOT place objects, including
communication equipment, in the area over the air bag or in the air bag deployment
area. If the communication equipment is improperly installed and the air bag inflates,
serious injury could occur.
• Mount components securely on strong surfaces to prevent shifting that could
cause injury or interfere with safe vehicle operation. Always use the supplied
mounting hardware
• Mounted components and attached wires or cables must not interfere with seating
or leg space.
• Route cables so they are protected from pinching, sharp edges, and crushing. Keep
all in-line connectors easily accessible.
• This car kit is intended for use in 12 volt negative ground systems only. The car kit
draws less than 3 amps. Make sure that the vehicle's electrical system can supply
this current.

Installation procedure

Caution: This car kit must be connected to a maximum 10A fuse in the car fuse panel
to prevent fire or other damages if a short circuit should occur somewhere in the
Junction Box. Before installation, unpack, assemble, and test all components on a
service bench.
Installing the Bluetooth junction box
Please refer to figure 1 on page 2.
Mount the box using the screws provided.
The best location for the Bluetooth junction box is under the dash. The box must be
protected from dirt and moisture and have adequate space for cooling and to allow
for cable connection.
5
English