Enjoying A Multi-Channel Super Audio Cd; Multi-Channel Management Function; Checking The Contents Of The Program - Sony SCD SCD-C2000ES Operating Instructions Manual

To resume Continuous Play
Press PLAY MODE repeatedly (or CONTINUE
on the remote) in stop mode until "SHUF" and
"PGM" disappear.
Tip
The program remains even after Program Play ends.
Press N to play from the beginning of the program
again. The program remains even if you stop play.
Notes
• If you turn off the player, disconnect the power cord,
press A OPEN/CLOSE on the player, or switch the
playback layer or area, the program will be erased.
• If you switch the playback layer or area during
Program Play, a single track only will be played back
from its beginning, and then the program will be
erased.
Checking the contents of the
program
Before you start playing or while the player
is playing, press CHECK on the remote
repeatedly.
Each time you press the button, the disc and
track numbers will appear in the display in the
programed order.
If you press CHECK on the remote while the
player is playing, the programed disc and track
numbers will appear starting with the currently
playing program step.
Changing the contents of the
program
You can change the contents of the program in
stop mode.
To
Erase a track
Erase from the
last track in the
program
Add a track to the
end of the
program
Erase all tracks
US
16
Do the following:
1
Press CHECK on the remote
repeatedly until the track
number you want to erase
appears.
2
Press CLEAR on the remote.
Press CLEAR on the remote.
Each time you press the button, the
last track of the program is erased.
Perform Steps 2 through 3.
Hold down CLEAR on the remote
or x (for about 2 seconds) until
"PGM CLEAR" appears in the
display.
Enjoying a Multi-channel
Super Audio CD
— Multi-channel management
function
This player is equipped with a Multi-channel
management function that sets the playback
mode of the Super Audio CD by the DSD-DSP
(built into the player) according to the layout or
size of your speaker.
Front speakers
L
Center speaker
Sub woofer
L
Surround speakers
To set the Multi-channel management function,
select the appropriate preset playback mode (2
channel mode or Multi-channel mode), and then
adjust the output level balance for each speaker
(only in the case of Multi-channel mode).
Notes
• This features only work when you play the Super
Audio CD.
• You may not be able to adjust the output level
balance depending on the speaker layout mode that
you selected.
R
R