Sharp LYNX 3D SH-03C Docomo Instruction Manual page 67

Security codes used on the
FOMA terminal
Some functions for convenient use of the FOMA
terminal require security codes. In addition to the
Lock No. used for various handset operations, use
security codes such as the network security code
when using network services. Use security codes
with various functions to fully utilize the FOMA
terminal.
Entered Lock No. (security code for each
function) and PIN code are marked with [ ・ ].
Precautions for various security codes
Do not use easily estimated numbers for
security codes to be set such as "birthday",
"part of a phone number", "address or room
number", "1111" or "1234". Keep a separate
memo of security codes.
Keep security codes private. If the security
codes are found and improperly used by others,
DOCOMO shall not be liable for any loss of the
users.
If you forget your security codes, you are
required to bring your identification (a driver's
license, etc.), your FOMA terminal and your
UIM to a docomo Shop.
For details, contact "General Inquiries" on the
back of this manual.
PUK (PIN Unlock Key) is described in the
agreement form (customer copy) you received
at the time of subscription at a docomo Shop. If
you made a subscription outside a docomo
Shop, bring your identification (a driver's
license etc.) and your UIM to a docomo Shop or
contact "General Inquiries" on the back of this
manual.
Lock No. (for various functions)
■
Lock No. is set to [0000] by default but you can
change the number (nP. 64).
If you enter the wrong Lock No. five times
continuously, you cannot enter it for 30 seconds.
Network security code
■
Network security code is a four-digit code required
for confirming the subscriber's identity when an
order is received at a docomo Shop or docomo
Information center or used for accessing various
network services. You set arbitrary code at the time
of subscription but you can change the code.
For those with "docomo ID/password" of the
general support site "My docomo" designed for PC
(in Japanese only), the registration procedure for a
new network security code is available from PC.
Refer to the inside back cover of this manual for
details on "My docomo".
PIN1 code/PIN2 code
■
A UIM has two security codes: PIN1 code and PIN2
code. These security codes are set to [0000] by
default but you can change the code (nP. 64).
The PIN1 code is a four- to eight-digit security code
that is entered when a UIM is inserted or when the
FOMA terminal is turned on to prevent
unauthorized use by a third party. Making/
Receiving a call and the terminal operation are
enabled by entering PIN1 code.
※ This FOMA terminal does not support PIN2
code.
Use the previously set PIN1/PIN2 code when
inserting a UIM that has been used in another
FOMA terminal. It is [0000] if the setting has not
been changed.
65
Various Settings