Headphones Operation; Controls; Replacing The Headphone Batteries - Dodge Durango SRT 2018 Owner's Manual

11. KEYPAD — Push to navigate chapters or
titles.
12. ■ (Stop) — Stops disc play.
13. — Push and hold to fast rewind
through the current audio track or video
chapter.
14. — Mutes headphone audio.
15. BACK — Push to exit out of menus or return
to source selection screen.
16. — Push to navigate menus.
17. OK — Push to select the highlighted option
in a menu.
18. — Push to navigate menus.
19. — Push to navigate menus.

Headphones Operation

The headphones receive two separate channels
of audio using an infrared transmitter from the
video screen.
If no audio is heard after increasing the volume
control, verify that the screen is turned on, the
channel is not muted and the headphone chan-
nel selector switch is on the desired channel. If
audio is still not heard, check that fully charged
batteries are installed in the headphones.
296
Rear Seat Entertainment Headphones
1 — Power Button
2 — Volume Control
3 — Channel Selection Switch

Controls

The headphone power indicator and controls
are located on the right ear cup.
NOTE:
The rear video system must be turned on before
sound can be heard from the headphones. To
conserve battery life, the headphones will auto-
matically turn off approximately three minutes
after the rear video system is turned off.
Changing the Audio Mode for Headphones
1. Ensure the Remote Control channel/screen
selector switch is in the same position as the
headphone selector switch.
NOTE:
• When both the headphone and the remote
control channel selector switches are on
Channel 1, the Remote is controlling Channel
1 and the headphones are tuned to the audio
on Channel 1.
• When both the headphone and the remote
control channel selector switches are on
Channel 2, the Remote is controlling Channel
2 and the headphones are tuned to the audio
on Channel 2.
2. Push the SOURCE button on the remote
control.
3. Pushing the SOURCE button will advance to
the next mode.
4. When the Mode Selection menu appears on
screen, use the cursor buttons on the remote
control to navigate to the available modes
and push the OK button to select the new
mode.
5. To cancel out of the Mode Selection menu,
push the BACK button on the remote control.

Replacing The Headphone Batteries

Each set of headphones requires two AAA bat-
teries for operation. To replace the batteries:
1. Locate the battery compartment on the left
ear cup of the headphones, and then slide
the battery cover downward.