Enabling And Disabling Parksense; Service The Parksense Park Assist System - Dodge Durango SRT 2018 Owner's Manual

Hide thumbs Also See for Durango SRT 2018:
Table of Contents

Advertisement

Front Distance
Greater than
(inches/cm)
47 inches (120 cm)
Audible Alert
Chime
Arcs-Left
Arcs-Center
Arcs-Right
Radio Volume Re-
duced
NOTE:
ParkSense will reduce the volume of the radio, if
on, when the system is sounding an audio tone.
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist
audible alert (chime) after approximately 3 sec-
onds when an obstacle has been detected, the
vehicle is stationary, and brake pedal is applied.
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be
selected from the Uconnect System. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
The chime volume settings include low, me-
dium, and high. The factory default volume
setting is medium.
ParkSense will retain its last known configura-
tion state through ignition cycles.
186
WARNING ALERTS FOR FRONT
47-39 inches
(120-100 cm)
None
None
None
None
None
4th Solid
None
None
No
No

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch.
When the ParkSense switch is
pushed to disable the system, the
instrument cluster will display the
"PARKSENSE OFF" message for
approximately five seconds. Refer
to "Instrument Cluster Display" in "Getting To
Know Your Instrument Panel" for further infor-
mation. When the gear selector is moved to
REVERSE and the system is disabled, the
instrument cluster display will display the
"PARKSENSE OFF" message for as long as the
vehicle is in REVERSE.
NOTE:
When ParkSense is disabled and the gear se-
lector is moved to the DRIVE position, no warn-
ing message will be displayed.
39-25 inches
25-12 inches
(100-65 cm)
(65-30 cm)
None
Fast
None
2nd Flashing
3rd Flashing
2nd Flashing
None
2nd Flashing
No
Yes
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and the system requires service, the
ParkSense switch LED will blink momentarily,
and then the LED will be on.
Service The ParkSense Park Assist
System
During vehicle start up, when the ParkSense
System has detected a faulted condition, the
instrument cluster will actuate a single chime,
once per ignition cycle, and it will display the
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS",
WIPE
"PARKSENSE UNAVAILABLE SERVICE RE-
QUIRED" message for five seconds. When the
gear selector is moved to REVERSE and the
Less than 12 inches
(30 cm)
Continuous
1st Flashing
1st Flashing
1st Flashing
Yes
"PARKSENSE
UNAVAILABLE
FRONT
SENSORS",
or
the

Advertisement

Table of Contents
loading

Table of Contents