Panasonic DMR-UBS80EG Service Manual page 40

Error Code Diagnosis contents
U76 HDMI connection error
U77 Illegal disc error
U88 The unit is carrying out its
recovery process.
(with a disc in the disc tray)
U99 Hang-up
H19 02 Inoperative fan motor
F00 No error information
F34 Initialization error when main
microprocessor is started up
for program recording
F58 Drive hardware error
F74 HDMI Device Key
Communication error.
F75 HDMI Device Key Information
error
SET Remote control code error
CODE *
UNSUPPO Unsupported disc error
RT
NO READ Disc read error
Description
HDMI cannot be output because you are
connected to a model that does not support
copyright protection.
Due to the current disc not having
authorized copyright information, video
output is not performed.
• The unit detected an error while
recording or playing with a disc in the
disc tray. The unit is carrying out its
recovery process. This process restores
the unit to normal operation. The unit is
not broken.
Wait until the message disappears.
Displayed when communication error has
occurred between Main microprocessor
and Timer microprocessor.
When inoperative fan motor is detected
after powered on, the power is turned off
automatically.
The event is saved in memory.
Initial setting for error code in memory
(Error code Initialization is possible with
error code initialization and main unit
initialization.)
When initialization error is detected after
starting up main microprocessor for
program recording, the power is turned off
automatically.
The event is saved in memory.
When drive unit error is detected, the event
is saved in memory.
HDMI connection could not be
authenticated due to a transfer malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't
operate normally.
• When device key information recorded
is damaged.
HDMI connection could not be
authenticated due to an internal data
malfunction.
Factor of HDMI Device key-road failure
• When HDMI LSI is damaged.
• When the bus line of I2C doesn't
operate normally.
• When device key information recorded
is damaged.
Display appears when main unit and
remote controller codes are not matched.
*An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty.
*A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
40
Monitor Display Automatic FL display
No display
No display
No display
No display
Displayed is left until the [POWER]
key is pressed.
No display No display
No display No display
No display No display
No display No display
No display
No display
No display
"*" is remote controller code of the
main unit.
Display for 5 seconds.
"This disc is Display for 5 seconds.
incompatible."
"Cannot read.
Please check the
disc."