Basic Operation; Power-Up; Com Radio; Selecting A Com Frequency - Garmin GTR 200 Pilot's Manual

GTR 200/200B

BASIC OPERATION

POWER-UP

Turn the GTR 200/200B on by either turning the Power/Volume/Squelch
knob clockwise or, if installed, turning on the master switch that powers the
radios.

COM RADIO

New frequencies are first selected as a Standby frequency and then
toggled to the Active side with the Frequency Transfer Key . While viewing
the Standby frequency display, use the LARGE and SMALL knobs on the
right side of the GTR 200/200B to select the desired frequency. Turn the
LARGE and SMALL knobs, clockwise to increase and counterclockwise to
decrease frequency values. Standby frequency selections is not inhibited
during transmit.
When connected to a device that provides nearby frequency information,
nearby station identifiers will be shown for the selected frequency.

Selecting a COM Frequency:

1) Turn the LARGE Knob to change the value in one MHz increments.
2) Turn the SMALL Knob to change the value in 25 kHz increments.
3) Press the Frequency Transfer Key to toggle the Standby frequency to
the Active frequency.
4
Identifier and Type Shown
for the Selected Frequency
COM Frequency Selection
Garmin GTR 200/200B Pilot's Guide 190-01553-01 Rev. G