Remote Control - Aiwa CX-NMT90 Operating Instructions Manual

To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T-shape and fix its ends to
the wall.
AM
loop antenna:
Position for the best reception.
m
Be sure to connect the speaker cords correctly. Improper
connections can cause short circuits in the SPEAKERS
terminals.
Do not leave objects generating magnetism near the speakers.
Do not bring the FM antenna near metal objects or curtain rails.
Do not bring the AM antenna near other optional equipment,
the stereo system itself, the AC cord or speaker cords, since
noise will be picked up.
Do not unwind the AM antenna wire.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended.
Connect the outdoor antenna to the FM 75 Q terminals.
To mount the surround speakers on the wall
Mount each speaker on a s~ot that can hold its weiaht.
To
connect other optional equipment+ page 23.
I
m
Sound is not heard from the surround speakers when the
SURROUND is set to off.
To change the
AM
tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
m
REMOTE CONTROL
inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximu"m operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
c The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
When the AM tuning interval is changed, all preset stations (see
"PRESETTING STATIONS on page 8) are cleared. The preset
stations have to be set again.
5
ENGLISH