Basic Operations - Aiwa CX-NMT90 Operating Instructions Manual

BASIC OPERATIONS
LOADING DISCS
DISC
Press the CD button, then press the A OPEN/
CLOSE button to open the disc compartment. Load
disc(s) with the label side up.
To play one or two discs,
place the discs on tray 1 and 2.
To play three discs,
press the DISC CHANGE button to rotate
the trays after placing two discs. Place the third disc on tray 3.
Close the disc compartment by pressing the A OPEN/CLOSE
To play one disc only, press one of the DISC DIRECT
PLAY buttons.
The selected disc is played once.
To play with the remote control
Press the DISC DIRECT PLAY button, then press one of the
numbered buttons 1 to 3 within 3 seconds to select a disc.
To stop play,
press the button.
To pause play,
press the II button. To resume play, press again.
To search for a particular point during playback,
keep the
44 or> button pressed and release the button at the desired
point.
To skip to the beginning of a track during playback, press
the + or - button repeatedly.
To remove discs, press the = OPEN/CLOSE button.
To
start play
when the power is off (Direct Play Function)
Press the CD button. The power is turned on and play of the
loaded disc(s) begins.
When the A OPEN/CLOSE button is pressed, the power is also
turned on,
To check the remaining time
Press the CD EDIT/CHECK button during play, The amount of
time remaining until all tracks finish playing is displayed, To
restore the playing time display, repeat the above.
Selecting a track with the remote control
1
Press the DISC DIRECT PLAY button, then press one of the
numbered buttons 1 to 3 within 3 seconds to select a disc.
2 Press the numbered buttons and the +10 button to select a
track.
Example:
To select the 25th track, press the +10, +10 and 5 buttons.
To select the 10th track, press the +1 O and O buttons.
The selected track starts to play and continues to the end of
that disc.
Tray number of the
disc to be played Total playing time
Replacing discs during play
While one disc is playing, the other discs can be replaced without
interrupting play.
1
Press the DISC CHANGE button.
2 Remove the discs and replace with other discs.
3 Press the A OPEN/CLOSE button to close the disc
compartment.
Total number of tracks
m
PLAYING DISCS
Load discs.
To play all discs in the disc compartment, press the
+> button.
Play begins with the disc on tray 1.
When loading an 8-cm (3-inch) disc, put it onto the inner circle
of the tray.
Do not place more than one compact disc on one disc tray.
Do not tilt the unit with discs loaded. Doing so may cause
malfunctions,
Elapsed playing time
Number of track
being played
9
ENGLISH