Interface Panel - YASKAWA DX200 Instructions Manual

HW1481731
4

Interface Panel

4 Interface Panel
The interface screen is configured as in the following figure. For I/O
assignment of the button switches and status display LEDs, refer to the table
below. Do not use the general output No. in the table if FSE-Tool is used.
1. Button switch
General Signal Name Contents
Output No.
11250 Start
11251 Stop
11252 Mode switch
11230 Zero reset
11231 Coordinate
system
switch
2. Status display LED
General Signal Name Contents
Output No.
11260 Running
11262 Mode switch
11263 TOUCH
Setting
completed
11264 FIT
Setting
completed
11265 INSERT
Setting
completed
4-1
Operation start
(Tuning Step 1, 2, TOUCH, FIT, INSERT)
Operation stop
(Tuning Step 1, 2, TOUCH, FIT, INSERT)
ON: Operation from PC (FSE-Tool) valid
OFF: Operation from PP (JOB) valid
Zero reset of the sensor value
The coordinate system while monitoring
With button depressed: LED ON
ON: [PC MODE] LED ON
OFF: [PP MODE] LED ON
With the {TOUCH COMP SET} button pressed on
PC: LED ON
Operation end: LED OFF
With the {FIT COMP SET} button pressed on PC:
LED ON
Operation end: LED OFF
With the {INSERT COMP SET} button pressed
on PC: LED ON
Operation end: LED OFF
HW1481731
79/104