J300 Control Panel - Jacuzzi LED Series Manual

3.2 J300 Control Panel

2-pump J-375, J-365, J-355, J-345 and J-335
A
B
C
Display shown for example purposes only, actual water tem-
perature display will vary.
A. 2013 P/N 6600-504 SMT panel
(replaced 6600-235 early in 2013)
B. 2008-2012 P/N 2600-328
Button
LED Display: Can display current water temperature (default display), water temperature setpoint, selected
A
filtration/heating mode, and error messages.
Warmer Button: Increases water temperature setpoint.
B
Cooler Button: Decreases water temperature setpoint.
C
Light Button: Turns waterfall, footwell, pillows and cupholder lights on in unison. Press once for high intensity,
a second time for medium intensity, a third time for low intensity, a fourth time to turn off. The displayed color
D
is changed using the light mode button (E) below.
Light Mode Button: Selects one of 4 color modes for waterfall, footwell, pillows and cupholder lights.
E
Jets 1 Button: Turns jets pump #1 on and off. Press once for low speed; a second time for high speed and a
F
third time to turn off.
Jets 2 Button: Turns high-speed jets pump #2 on and off. Press once to turn on; a second time to turn off
G
(2-pump models only)
Heat Indicator: Lit when heater is on.
H
• Temperature Adjustment: 65 to 104°F (18 to 40°C); temperature override not possible. Software default setting is
100°F (38°C).
• Light System Operation: Light runs for 2 hours then shuts off.
• Jets Button Operation: Jets run for 20 minutes after activated then turn off automatically to conserve energy.
Simply press JETS Button to continue operation for an additional 20 minutes.
H
G
F
E
D
OPERATION DETAILS
1-pump J-315 and J-325
A
B
C
Display shown for example purposes only, actual water tem-
perature display will vary.
A. 2013 P/N 6600-503 SMT panel
(replaced 6600-237 early in 2013)
B. 2008-2012 P/N 2600-331
Function
H
F
E
D
5