Introduction - Kohler 14RCA Manual

This manual provides operation and maintenance
instructions for residential/commercial
14/20RCA/RCAL generator sets equipped with the
RDC2 generator set/transfer switch controller. See
Figure 1.
Kohler strongly recommends that only factory-
authorized distributors or dealers install and
service the generator.
Have the generator set installed by an authorized
distributor/dealer or service technician. Refer to the
Installation Manual for installation instructions.
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual. Keep this manual with the
equipment for future reference.
The equipment service requirements are very important
to safe and efficient operation. Inspect the parts often
and perform required service at the prescribed intervals.
Obtain service from an authorized service distributor/
dealer to keep equipment in top condition.
Figure 1 Generator Set
TP-7092 8/18
List of Related Literature
model
Figure 2 identifies literature available for the generator
sets covered in this manual and related accessories.
Only trained and qualified personnel should install or
service the generator set.
Generator Set Literature
Specification Sheet, 14RCA
Specification Sheet, 14RCAL
Specification Sheet, 20RCA
Specification Sheet, 20RCAL
Installation Manual, Generator Set
Service Manual, Generator Set
Transfer Switch Literature
Operation/Installation Manual,
Model RXT Automatic Transfer Switch
Operation/Installation Manual,
Model RDT Automatic Transfer Switch
Accessory Literature
User Guide, OnCuer Plus
Technical Manual, OnCuer Plus
Operation Manual, SiteTecht Software
Installation Instructions,
Load Shed Kit
Installation Instructions,
Programmable Interface Module (PIM)
Installation Instructions, PowerSyncr
Automatic Paralleling Module (APM)
Figure 2 Related Literature
aac11780

Introduction

Part Number
G4-270
G4-271
G4-272
G4-273
TP-7091
TP-7093
TP-6807
TP-6345
TP-7006
TP-7007
TP-6701
TT-1609
TT-1584
TT-1596
Introduction 11