Table of Contents
Advertisement
JR
POWER ANTENNA - EXPORT
DIAGNOSIS AND TESTING - POWER ANTENNA
- EXPORT
Refer to the appropriate wiring information. The
wiring information includes wiring diagrams, proper
wire and connector repair procedures, further details
on wire harness routing and retention, as well as
pin-out and location views for the various wire har-
ness connectors, splices and grounds.
(1) Using an ohmmeter, check for continuity
between the antenna body and ground. There should
be no measurable resistance. If OK, go to Step 2. If
not, repair or clean ground as necessary.
(2) Disconnect the wire harness connector at the
antenna. Check for battery voltage at pin A1. If OK,
go to Step 3. If not, check circuit fuse or check for a
shorted or open wire.
(3) With the ignition in the ON or ACC position,
turn radio ON and check for battery voltage at pin
A2. If OK, replace power antenna (Refer to 8 - ELEC-
TRICAL/AUDIO/ANTENNA - REMOVAL). If not,
check for a shorted or open wire.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
Fig. 3 POWER ANTENNA - TYPICAL
(2) Disconnect drain tube.
(3) Disconnect electrical connector.
(4) Disconnect antenna cable.
(5) Remove mounting bolts from antenna (Fig. 3).
(6) Pull antenna through grommet in quarter
panel.
INSTALLATION
(1) Push antenna up through grommet in quarter
panel.
(2) Install mounting bolts to antenna. Tighten to
12 N·m (110 in. lbs.).
(3) Connect antenna cable.
(4) Connect electrical connector to antenna.
(5) Connect drain tube.
(6) Install ground strap (if equipped) and fastener.
Tighten to 12 N·m (110 in. lbs.).
(7) Connect battery negative cable.
REMOTE SWITCHES
DESCRIPTION
Remote radio control switches are rocker-type
switch units (Fig. 4) are mounted in the upper spoke
covers of the rear (instrument panel side) steering
wheel trim cover. The switch unit on the left side is
the seek switch and has seek up, seek down, and pre-
set station advance switch functions. The switch unit
on the right side is the volume control switch and
has volume up, volume down, and mode advance
switch functions.
Fig. 4 REMOTE RADIO SWITCHES
1 - PRESET ADVANCE
2 - SEEK
3 - MODE ADVANCE
4 - VOLUME
The two remote radio switch units are each
retained in a mounting hole located on opposite sides
of the rear steering wheel trim cover by four integral
snap features. A plastic bracket on the back of each
switch unit provides additional support for the unit
by extending towards the center of the steering
wheel where it is clamped between the steering
wheel armature and the steering wheel rear trim
cover mounting boss by the trim cover mounting
screw.
AUDIO/VIDEO
8A - 7
Advertisement
Table of Contents
