Suzuki Wagon R Manual page 463

6A1-8 ENGINE MECHANICAL
2) Install special tool (Oil pressure gauge) to vacated threaded
hole.
Special Tool
(A): 09915-77310
3) Start engine and warm it up to normal operating temperature.
4) After warming up, raise engine speed to 4,000 r/min and mea-
sure oil pressure.
Oil pressure specifications: 360 – 440 kPa
5) After checking oil pressure, stop engine and remove oil pressure
gauge.
6) Before reinstalling oil pressure switch (1), be sure to wrap its
screw threads with a sealing tape and tighten switch to specified
torque.
NOTE:
If sealing tape edge is bulged out from screw threads of
switch, cut it off.
Tightening Torque
.
(a): 14 N m (1.4 kg-m, 10.5 lb-ft)
7) After installing oil pressure switch, start engine and check oil
pressure switch for oil leakage.
VALVE LASH (CLEARANCE)
1) Remove negative cable at battery.
2) Remove cylinder head cover referring to item "Cylinder Head
Cover" in this section.
3) Remove right side of engine under cover from body.
4) Remove air cleaner assembly to observe "V" mark (2) on crank-
shaft pulley (1).
5) Using 17 mm socket, turn crankshaft pulley clockwise until "V"
mark (in white paint) on pulley aligns with "0" (zero) calibrated
on timing belt cover.
2
(3.6 – 4.4 kg/cm , 51.2 – 62.6 psi)
at 3,960 – 4,040 r/min (rpm)