Vehicle Security Alarm - If Equipped; To Arm The System; To Disarm The System; Rearming Of The System - Chrysler 300 SRT 2019 Owner's Manual

NOTE:
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The vehicle security alarm monitors the vehicle
doors for unauthorized entry and the keyless
push button ignition for unauthorized operation.
While the vehicle security alarm is armed, inte-
rior switches for door locks and trunk release
are disabled. If something triggers the alarm, the
vehicle security alarm will provide the following
audible and visible signals: the horn will pulse,
the park lamps and/or turn signals will flash, and
the vehicle security light in the instrument clus-
ter will flash.

To Arm The System

Follow these steps to arm the vehicle security
alarm:
1. Make sure the vehicle's ignition is placed in
the OFF mode. Refer to "Ignition Switch" in
"Getting To Know Your Vehicle" for further
information.
2. Perform one of the following methods to lock
the vehicle:
• Push lock on the interior power door lock
switch with the driver and/or passenger door
open.
• Push the lock button on the exterior Passive
Entry Door Handle with a valid key fob avail-
able in the same exterior zone (refer to "Key-
less Enter-N-Go — Passive Entry," located in
"Doors" in "Getting To Know Your Vehicle" for
further information).
• Push the lock button on the key fob.
3. If any doors are open, close them.
NOTE:
Security System Manual Override
The vehicle security alarm will not arm if you
lock the doors using the manual door lock
plunger.

To Disarm The System

The vehicle security alarm can be disarmed
using any of the following methods:
• Push the unlock button on the key fob.
• Grasp the Passive Entry Unlock Door
Handle, if equipped. Refer to "Keyless Enter-
N-Go — Passive Entry," located in "Doors" in
"Getting To Know Your Vehicle" for further
information.
• Push the Keyless Enter-N-Go ignition button
(requires at least one valid key fob in the
vehicle).
NOTE:
• The driver's door key cylinder and the trunk
button on the key fob cannot arm or disarm
the vehicle security alarm.
• When the vehicle security alarm is armed, the
interior power door lock switches will not
unlock the doors.
The vehicle security alarm is designed to protect
your vehicle. However, you can create condi-
tions where the system will give you a false
alarm. If one of the previously described arming
sequences has occurred, the vehicle security
alarm will arm regardless of whether you are in
the vehicle or not. If you remain in the vehicle
and open a door, the alarm will sound. If this
occurs, disarm the vehicle security alarm.
If the vehicle security alarm is armed and the
battery becomes disconnected, the vehicle se-
curity alarm will remain armed when the battery
is reconnected; the exterior lights will flash, the
horn will sound. If this occurs, disarm the vehicle
security alarm.

Rearming Of The System

If something triggers the alarm, and no action is
taken to disarm it, the vehicle security alarm will
turn the horn off after 29 seconds, five seconds
25