To Enter Remote Start Mode; General Information; Vehicle Security Alarm - If Equipped; To Arm The System - Chrysler Pacifica Hybrid 2018 User Manual

To Enter Remote Start Mode

Push and release the Remote Start button on the
key fob twice within five seconds. The vehicle doors
will lock, the turn signals will flash twice, and the
horn will chirp twice. Then the vehicle will start, and
the vehicle will remain in the Remote Start mode for
a 15-minute cycle.
NOTE:
• The vehicle can be started two consecutive times
(two 15-minute cycles) from the key fob. However,
the ignition must be placed in the ON/RUN posi-
tion before you can repeat the start sequence for a
third cycle.
• The park lamps will turn on and remain on during
Remote Start mode.
• For security, power window operation is disabled
when the vehicle is in the Remote Start mode.

General Information

The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this ve-
hicle:
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS stan-
dard(s). Operation is subject to the following two
conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
VEHICLE SECURITY
ALARM — IF EQUIPPED
The vehicle security alarm monitors the vehicle
doors for unauthorized entry and the ignition switch
for unauthorized operation. When the alarm is acti-
vated, the interior switches for door locks, power
sliding doors and power liftgate are disabled. The
vehicle security alarm provides both audible and
visible signals. If something triggers the alarm, the
vehicle security alarm will provide the following au-
dible and visible signals: the horn will pulse, the park
lamps and/or turn signals will flash, and the vehicle
security light in the instrument cluster will flash.

To Arm The System

Follow these steps to arm the vehicle security alarm:
1. Make sure the vehicles ignition is cycled to the
"OFF" position (refer to "Starting The Engine"
in "Starting And Operating" for further
information).
• For vehicles equipped with Keyless Enter-
N-Go — Passive Entry, make sure the vehicle
ignition system is OFF.
29