Electronic Steering Wheel Lock - If Equipped; Remote Start - If Equipped; How To Use Remote Start - If Equipped - Chrysler 300 SRT 2019 Owner's Manual

WARNING! (Continued)
brake, place the engine in the OFF posi-
tion, remove the key fob from the vehicle
and lock your vehicle. If equipped with
Keyless Enter-N-Go, always make sure the
keyless ignition is in "OFF" position, re-
move the key fob from the vehicle and lock
the vehicle.
• Never leave children alone in a vehicle, or
with access to an unlocked vehicle.
• Allowing children to be in a vehicle unat-
tended is dangerous for a number of rea-
sons. A child or others could be seriously or
fatally injured. Children should be warned
not to touch the parking brake, brake pedal
or the gear selector.
• Do not leave the key fob in or near the
vehicle, or in a location accessible to chil-
dren, and do not leave the ignition of a
vehicle equipped with Keyless Enter-N-Go
in the ON/RUN mode. A child could operate
power windows, other controls, or move
the vehicle.
• Do not leave children or animals inside
parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
22
CAUTION!
An unlocked vehicle is an invitation for
thieves. Always remove key fob from the
vehicle and lock all doors when leaving the
vehicle unattended.
Electronic Steering Wheel Lock — If
Equipped
Your vehicle may be equipped with a passive
electronic steering wheel lock. This lock pre-
vents steering the vehicle with the ignition OFF.
The steering wheel lock releases with the igni-
tion ON. If the lock does not disengage and the
vehicle does not start, turn the wheel to the left
and right to disengage the lock.
REMOTE START — IF
EQUIPPED
How To Use Remote Start — If
Equipped
Push remote start button on the key
fob twice within five seconds. Push-
ing the remote start button a third
time shuts the engine off.
To drive the vehicle, push the un-
lock button, and push the ignition to the ON/
RUN position.
NOTE:
• With remote start, the engine will only run for
15 minutes (timeout) unless the ignition is
placed in the ON/RUN position.
• The vehicle must be started with the key after
two consecutive timeouts.
All of the following conditions must be met
before the engine will remote start:
• Gear selector in PARK
• Doors closed
• Hood closed
• Trunk closed
• Hazard switch off
• Brake switch inactive (brake pedal not
pushed)
• Battery at an acceptable charge level
• Check engine light shall not be present
• System not disabled from previous remote
start event
• Vehicle alarm system indicator flashing
• Ignition in STOP/OFF position
• Fuel level meets minimum requirement
• Vehicle Security Alarm is not signaling an
intrusion