Vehicle Storage; Bodywork; Protection From Atmospheric Agents; Body And Underbody Maintenance - Chrysler 300 SRT 2019 Owner's Manual

Table of Contents

Advertisement

Tire Rotation — Same Tire Size On Front And
Rear Axle
The suggested rotation method for vehicles
equipped with non directional three season and
all season tires is the "forward-cross" as shown
in the following diagram.
Tire Rotation

VEHICLE STORAGE

If you are leaving your vehicle dormant for more
than 21 days, you may want to take these steps
to protect your battery.
• Disconnect the negative cable from the bat-
tery.
• Anytime you store your vehicle, or keep it out
of service (e.g., vacation) for two weeks or
more, run the air conditioning system at idle
for about five minutes in the fresh air and high
blower setting. This will ensure adequate
system lubrication to minimize the possibility
of compressor damage when the system is
started again.

BODYWORK

Protection From Atmospheric
Agents
Vehicle body care requirements vary according
to geographic locations and usage. Chemicals
that make roads passable in snow and ice and
those that are sprayed on trees and road sur-
faces during other seasons are highly corrosive
to the metal in your vehicle. Outside parking,
which exposes your vehicle to airborne contami-
nants, road surfaces on which the vehicle is
operated, extreme hot or cold weather and other
extreme conditions will have an adverse effect
on paint, metal trim, and underbody protection.
The following maintenance recommendations
will enable you to obtain maximum benefit from
the corrosion resistance built into your vehicle.
What Causes Corrosion?
Corrosion is the result of deterioration or re-
moval of paint and protective coatings from your
vehicle.
The most common causes are:
• Road salt, dirt and moisture accumulation.
• Stone and gravel impact.
• Insects, tree sap and tar.
• Salt in the air near seacoast localities.
• Atmospheric fallout/industrial pollutants.

Body And Underbody Maintenance

Cleaning Headlights
Your vehicle is equipped with plastic headlights
and fog lights that are lighter and less suscep-
tible to stone breakage than glass headlights.
Plastic is not as scratch resistant as glass and
therefore different lens cleaning procedures
must be followed.
To minimize the possibility of scratching the
lenses and reducing light output, avoid wiping
with a dry cloth. To remove road dirt, wash with
a mild soap solution followed by rinsing.
Do not use abrasive cleaning components, sol-
vents, steel wool or other aggressive material to
clean the lenses.

Preserving The Bodywork

Washing
• Wash your vehicle regularly. Always wash
your vehicle in the shade using Mopar Car
Wash, or a mild car wash soap, and rinse the
panels completely with clear water.
• If insects, tar, or other similar deposits have
accumulated on your vehicle, use Mopar Su-
per Kleen Bug and Tar Remover to remove.
• Use a high quality cleaner wax, such as
Mopar Cleaner Wax to remove road film,
stains and to protect your paint finish. Take
care never to scratch the paint.
225

Advertisement

Table of Contents
loading

Table of Contents