asieps_tobira_IM_US.book 50 ページ 2012年1月17日 火曜日 午後3時48分
FUEL INJECTION (FUEL SYSTEMS)
18.Engine Control Module (ECM)
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the lower inner trim of passenger's
side. <Ref. to EI-51, REMOVAL, Lower Inner
Trim.>
3) Detach the floor mat of passenger's seat.
4) Remove the protect cover.
5) Remove the nuts (A) which hold ECM to bracket.
6) Remove the clip (B) from the bracket.
(B)
7) Disconnect the ECM connectors, and take out
the ECM.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
When replacing the ECM, be careful not to use the
wrong spec. ECM to avoid any damage on the fuel
injection system.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Engine Control Module (ECM)
FU-00009
FU-01029
(A)
(A)
FU-00316
FU(H4DOTC)-50