Troubleshooting Suggestions - Wells WV2HFG Owner's Manual

TROUBLESHOOTING SUGGESTIONS

SYMPTOM
No power to unit
Cooking appliances not energized
Hotplate (only) will not heat
Griddle (only) will not heat
Warmer Drawer will not heat
POSSIBLE CAUSE
Not plugged in or circuit breaker tripped
Filters not properly installed
(CHECK FILTERS lit)
Filters expended (SERVICE REQUIRED lit)
Ansul® system discharged or not cocked.
(Buzzer sounds)
Internal damage
Hotplate Temperature Control not set
Internal damage
Griddle Temperature Control not set
Internal damage
Drawer Temperature Control not set
Internal damage
23
RECOMMENDED REMEDY
Plug unit into power receptacle Reset circuit breaker
Install filters properly
Replace filters
Contact Ansul® Distributor for service.
Contact Authorized Wells Service Agent for repairs.
Set Hotplate Temperature Control to desired
temperature. Each hotplate is controlled
individually.
Contact Authorized Wells Service Agent for repairs.
Set Griddle Temperature Control to desired
temperature
Contact Authorized Wells Service Agent for repairs.
Set Drawer Temperature Control to desired
temperature
Contact Authorized Wells Service Agent for repairs.