Gear Shift Knob Removal; Installation; Holding Clutches Description; Operation - Chrysler Pacifica 2004 Service Manual

Hide thumbs Also See for Pacifica 2004:

Table of Contents

41AE/TE AUTOMATIC TRANSAXLE

GEAR SHIFT CABLE (Continued)

Fig. 270 Gearshift Cable Adjustment

1 - GEARSHIFT CABLE ADJUSTMENT SCREW

2 - GEARSHIFT CABLE

GEAR SHIFT KNOB

(1) Loosen, but do not remove, gearshift knob-to-

mechanism set-screw (Fig. 271).

(2) Remove gearshift knob.

Fig. 271 Gearshift Knob Removal/Installation

1 - SET SCREW

2 - GEARSHIFT KNOB

(1) Install gearshift knob (Fig. 271).

(2) Torque gearshift knob-to-mechanism set-screw

to 2 N·m (20 in. lbs.).

HOLDING CLUTCHES

Two hydraulically applied multi-disc clutches are

used to hold planetary geartrain components station-

ary while the input clutches drive others. The 2/4

and Low/Reverse clutches are considered holding

clutches and are contained at the rear of the trans-

axle case. (Fig. 272).

Fig. 272 2/4 and Low/Reverse Clutches

1 - FRONT PLANET CARRIER/REAR ANNULUS

2 - 2/4 CLUTCH

3 - L/R CLUTCH

4 - REAR PLANET CARRIER/FRONT ANNULUS

5 - REAR SUN GEAR

6 - FRONT SUN GEAR ASSEMBLY

NOTE: Refer to the "Elements In Use" chart in Diag-

nosis and Testing for a collective view of which

clutch elements are applied at each position of the

selector lever.

The 2/4 clutch is hydraulically applied in second

and fourth gears by pressurized fluid against the 2/4

clutch piston. When the 2/4 clutch is applied, the

front sun gear assembly is held or grounded to the

transaxle case.