Help And Service Information - ActionTec External 56K Call Waiting User Manual

Help and Service Information

General Troubleshooting Tips
This section presents solutions to some common problems you may experience when
installing your modem. Some solutions may not apply to your operating system or
environment. If you cannot resolve your difficulty, contact your dealer or vendor for
assistance.
Modem Does Not Respond To Commands
• Verify that the modem is turned on.
• Make sure the modem is installed into a serial (COM) port connector. Consult
your computer user's manual for the location and function of your installed
serial ports.
• Make sure the modem is initialized correctly. Issuing AT&F and pressing ENTER
(see "AT Commands") will reset the modem to its factory default settings.
• Make sure the baud rate setting in the communications software is set to the
correct value. An incorrect baud rate prevents the modem from operating properly.
Modem Does Not Dial
• Make sure the modem is turned on, and connected to a working phone line.
Replace the modem with a telephone to ensure that the line is working.
Modem Dials But Does Not Connect
• Make sure the communications software is configured to the same COM Port
and IRQ setting as the modem.
• Be sure the phone line is working properly. Replace the modem with a regular
phone and dial the number. If the line sounds noisy, you may have difficulty
connecting to the remote device.
Modem Experiences Errors Or Disconnects
• Make sure the phone line does not exhibit excess noise.
• Make sure RTS/CTS hardware flow control is enabled and XON/XOFF software
flow control is disabled in the communications software.
29