Onkyo TX-NR696 Instruction Manual page 132

Setting Item Default Value
Bluetooth Wakeup Off
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be selected. It can
be selected when the network function is activated.
„ 5. Works with SONOS
Change the settings to connect with the Sonos Connect.
Setting Item Default Value
Input Selector Off
Setting Details
This function wakes up the unit on standby by
connecting a BLUETOOTH-enabled device.
"On": When this function is used
"Off": When this function is not used
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption
is minimized by automatically entering the
HYBRID STANDBY mode where only the
essential circuits operate.
• This setting is fixed to "Off" if "Bluetooth" - "Auto
Input Change" is set to "Off".
Setting Details
Select the input selector to which the Sonos
Connect is connected.
• Selecting "Off" disables the interlock function
with Sonos.
Contents Connections
≫
Setting Item Default Value
Connected Device -
Output Zone Main
Preset Volume Main:
Zone 2:
132
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
Setting Details
Displays the Sonos Connect connected to the
same network as the network of this unit. Press
the ENTER button to select the connected Sonos
Connect.
• Products (e.g. Play:3 unequipped with an output
terminal) other than the Sonos Connect are also
displayed in the device list and selectable. In that
case, when playback on the Sonos side starts,
the input is switched, however, audio is not
output. Select the room name of the connected
Sonos Connect.
• Up to 32 devices can be displayed on the Sonos
product list screen. If you cannot find the Sonos
Connect to be interlocked, return to the previous
screen, turn off the product you want to interlock,
and try again.
• To use this function, set "Input Selector"
beforehand.
Select the zone where you want to listen to the
music.
"Main": Outputs audio only to the main room
(where this unit is located).
"Zone 2": Outputs audio only to the separate room
(ZONE 2).
"Main/Zone 2": Outputs audio to both the main
room and separate room.
• To use this function, set "Input Selector"
beforehand.
You can set the volume beforehand for playing
Last back the Sonos Connect. You can set volumes
for the main room (where this unit is located) and
Last separate room (ZONE 2) respectively. Select a
value from "Last" (Volume level before entering
standby mode), "Min", "1" to "99" and "Max".
• To use this function, set "Input Selector"
beforehand.
Setup
≫ ≫