Advertisement
3
WORK
3.1
Removing the seat
3.2
Mounting the seat
1
0 0 1
2
0 0 2
3.3
Removing the right underride guard
3.4
Installing the right underride guard
3.5
Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
–
Insert the ignition key into the seat lock.
–
Turn the ignition key to position
–
Lift up the seat at the rear, pull it back and remove from above.
–
Remove the ignition key.
100516-10
–
Hook projection
0 0 3
3
rear and push it forward at the same time. The two projections
into the frame.
–
Push locking pin
the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
100505-10
–
Remove screws
100581-10
–
Position right underride guard
Guideline
Remaining chassis screws
100581-11
.
C
of the seat into the storage compartment, lower the seat at the
1
into the lock housing and push the back of the seat down until
3
. Remove the right underride guard
1
. Mount and tighten screws
1
must be inserted
2
.
2
.
2
M6
10 Nm (7.4 lbf ft)
6
Advertisement
