Communications Errors In Positioning Mode - Siemens Simatic S5 IP 240 Manual

Error Messages
Table 14-7. Data Errors in Positioning Mode (Continued)
Error code for
Chan. 1 Chan. 2
65 95
69 99
14.4.3 Communications Errors
Communications errors can occur on direct data interchange with the IP 240. You must read out
the error code and extension from the IP 240's transfer buffer ( Chapter 11, "Direct Data Inter-
change").
Table 14-8. Communications Errors in Positioning mode
Error Code
(transfer buffer)
4000
41nn
14-6
Exten-
Description
sion
nn More than one synchronization mode selected.
nn = 00 HASY set
= 01 ZYSY set
= 02 SOSY set
nn Illegal data
nn = 00 Zero offset out of range
= 01 Zero offset exceeds final value of rotary axis
= 02 Illegal final value for rotary axis
= 03 BEE1 illegal
= 04 BEE2 illegal
= 05 BEE3 illegal
= 06 BEE1 illegal for position 0
= 07 BEE2 illegal for position 0
= 08 BEE3 illegal for position 0
Description
Protocol error
Illegal job number, nn=old job number
IP 240
EWA 4NEB 811 6120-02a