Miele G 7960 Operating Instructions Manual page 95

Problem
White residue is visible
on the crockery. Cloud-
ing has occurred on
glassware and cutlery.
The film can be wiped
off.
There are rust stains on
cutlery.
Cause and remedy
The rinse aid dosage is set too low.
 Increase the dosage (see "Settings" chapter,
"Rinse aid" section).
There is no salt in the salt reservoir.
 Fill the salt reservoir (see "Before using for the first
time", "Dishwasher salt" section).
The salt reservoir cap has not been screwed on cor-
rectly.
 Replace it, making sure that it screws back on cor-
rectly.
Unsuitable combination detergents were used.
 Switch to another detergent. If using tabs or
powder detergent, do not choose combination
products and ensure you refill the dishwasher salt
and rinse aid.
The water softener is programmed to too low a water
hardness level.
 Programme the water softener to a higher water
hardness level (see "Settings" chapter, "Water
hardness" section).
The affected items are not corrosion resistant.
 No remedy.
Purchase cutlery that is dishwasher-proof.
A programme was not run after dishwasher salt was
added. Traces of salt have got into the normal wash
cycle.
 Always run the  65 °C QuickPowerWash pro-
gramme with the Express programme option se-
lected and without any load in the dishwasher im-
mediately after adding dishwasher salt.
The salt reservoir cap has not been screwed on cor-
rectly.
 Replace it, making sure that it screws back on cor-
rectly.
Problem solving guide
95