Miele G 7960 Operating Instructions Manual page 88

Problem solving guide
Problem
The optical in-operation
indicator light is flash-
ing quickly.
At the end of the pro-
gramme, the alarm tone
sounds and the display
shows the following
message:

Fault F 601: A fault has
occurred; switch the appli-
ance off and back on again.
Restart the programme. If
the fault occurs again, call
Miele Service
The optical in-operation
indicator light is flash-
ing quickly.
At the end of the pro-
gramme, the alarm tone
sounds and the display
shows the following
message:
Problem found with Auto-
Dos. Please check AutoDos
system.
The dishwasher does
not switch off at the end
of the programme.
The wash items may not
be clean because an in-
sufficient amount of de-
tergent was dispensed.
The AutoDos function is
automatically deactiv-
ated during the pro-
gramme sequence.
88
Cause and remedy
There is a fault in the AutoDos.
 Switch the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see the "De-
tergent" chapter, "Automatic dispensing/AutoDos"
section).
 Activate the AutoDos function and restart the pro-
gramme.
If the fault message appears again, there is a tech-
nical fault. You can continue to use your dishwasher
by deactivating automatic dispensing in the Extras
menu of a programme and manually dispensing the
detergent via the detergent compartment.
 If you wish to use automatic dispensing again,
contact the Miele Customer Service Department.
An empty PowerDisk has been inserted or the Auto-
Dos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDos function was automatically deactivated.
 Switch the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the pouring channel of the AutoDos (see
"Detergent" chapter, "Cleaning the AutoDos" sec-
tion).
 Clean the lower spray arm (see "Cleaning and
care" chapter, "Cleaning the spray arms" section).
 Select OK to confirm each message.
 Activate the AutoDos function by confirming the
message
AutoDos available
 Start the programme again.
The programme duration will be extended by up to
2.5 hours to flush out the AutoDos detergent outlet.
using OK.