Cisco Catalyst 4500 E Series Supervisor Engine 9-E Installation And Configuration Note page 9

Call Out LED
1 STATUS
Indicates the status of the supervisor engine.
2 UID LED and switch combination
3 DC STATUS
The DC status LED indicates the current status
of the wireless daughter card.
4 LINK
Indicates the status of the 10/100/1000BASE-T
Ethernet management port.
5 SD
Indicates the status of the secure digital port.
LED Position or Meaning
Color
Green All diagniostic tests have passed after correct
image booting
Orange System boot or a diagnostic test is in
progress.
This is the redundant supervisor engine (in
redundant configurations).
Red A diagnostic test failed.
Off The supervisor engine is disabled or is not
powered up.
Blue A combination push button switch and LED
indicator. The blue LED can be turned on
either by pressing the UID switch on the front
panel or through software. The main purpose
of the beacon LED is to enable identification
from a remote location during configuration
or troubleshooting. The ability to turn on/off
the LED by pressing a switch allows you to
walk to the other side of a fully populated
rack and identify the switch. Pressing the blue
beacon LED switch toggles the beacon LED
on and off.
Green Normal operation
Blinking Green The daughter card is booting
Blinking Orange The system is waiting for user input
Orange A diagnostic test failed
Off No power to the daughter card
Green The link is operational
Off No signal is detected.
Green SD card is inserted
Off SD card has been removed, or the SD card is
bad
9