Cisco Catalyst 4500 E Series Supervisor Engine 9-E Installation And Configuration Note page 10

Call Out LED
6 ACTIVE SUP
The active supervisor engine LED indicates
whether the supervisor engine is active or in
standby mode in redundant supervisor engine
configurations.
7 UTILIZATION
8 UPLINK ACTIVE
Indicates if uplink ports 1 to 4 are active
9 UPLINK STATUS
Indicates the status of uplink ports 1 to 4.
10 UPLINKS ACTIVE
Indicates if the QSFP+ uplink ports 1 and 2 are
active
11 UPLINK STATUS
Indicates the status of the QSFP+ uplink ports 1
and 2.
10
LED Position or Meaning
Color
Green Supervisor engine is active (in redundant
supervisor engine configurations)
Off Supervisor engine is in standby mode (in
redundant supervisor engine configurations)
Green When the switch is operational, the eight CPU
utilization LEDs indicate the current traffic
load over the backplane as an approximate
percentage value. Each LED lit green
indicates approximately 12.5 percent of load.
Green 1-2 ACTIVE indicates ports 1 and 2 are
active
3-4 ACTIVE indicates ports 3 and 4 are
active
Off Ports are not active
Green The link is operational
Orange The link is disabled by user
Flashing Orange The power-on self-test indicates a faulty port
Off No signal is detected or there is a link
configuration failure
Green Port is active
Off Port is not active
Green The link is operational
Orange The link is disabled by user
Flashing Orange The power-on self-test indicates a faulty port
Off No signal is detected or there is a link
configuration failure