Table of Contents
Advertisement
Call
Feature
Out
4
USB Type A Host Port
5
USB mini Type B Console Port
6
Console port (RJ-45 connector)
7
10/100/1000 Ethernet Management Port
(RJ-45 connector)
8
SECURE DIGITAL slot
9
1-Gigabit Ethernet (GE) or 10-GE uplink
ports
Description
This USB port is a host port for an external USB disk drive. It supports
USB verion 2.0.
Note
Only a FAT32 formatted USB drive is
supported.
This USB connector is used as a console port allowing attachment to PCs
that are not equipped with an RS-232 interface.
For more information about console ports, see
This is a 10/100/1000 port that provides an RS-232 serial or console port
for system management.
For more information about console ports, see
The Ethernet management port is a Layer 3 host port to which you can
connect a PC. By default, the Ethernet management port is enabled. You
can use the Ethernet management port instead of the switch console port
for network management. This port is not active while the switch is
operating normally.
When connecting a PC to the Ethernet management port, you must
Note
assign an IP address.
The port has a LINK LED to indicate port status. See
E-Series Supervisor Engine 9-E LEDs, on page 8
For more information about the management port, see
Port, on page 16
A standard Secure Data (SD) memory card interface is provided on the
front panel
The port has an LED that indicates if a card is inserted. See
4500 E-Series Supervisor Engine 9-E LEDs, on page 8
The supervisor engine has four 1-GE or 10-GE ports. These ports require
either small form-factor pluggable (SFP) or SFP+ transceivers.
Ports are numbered 1 to 4 and have individual uplink status LEDs.
The ports also have ACTIVE LEDs that indicate the active port set. See
Cisco Catalyst 4500 E-Series Supervisor Engine 9-E LEDs, on page 8
For more information about uplink ports, see
Console Ports, on page 15
Console Ports, on page 15
Cisco Catalyst 4500
Ethernet Management
Cisco Catalyst
Uplink Ports, on page 16
7
Advertisement
Table of Contents
