Cisco Catalyst 4500 E Series Supervisor Engine 9-E Installation And Configuration Note page 14

Step 4
Remove the new supervisor module from the shipping packaging, being careful to handle the module using only the
module's metal tray or the front panel. Do not touch the printed circuit board or the connector pins.
Step 5 Pivot the two module ejector levers out and away from the faceplate
Figure 3: Installing the Supervisor Engine in the Chassis (Catalyst 4507R+E Shown)
Step 6
Grasp the switching module's front panel with one hand and place your other hand under the carrier to support the supervisor
module.
Step 7 Position the new module in the slot. Make sure that you align the sides of the module carrier with the slot guides on each
side of the chassis slot.
Step 8 Carefully slide the supervisor module into the slot. Pivot both ejector levers in simultaneously.
When installed correctly
• The notches on both the ejector levers engage the chassis sides.
• Both the ejector levers are parallel with the supervisor module faceplate to fully seat the module in the backplane
connector.
Note Always use the ejector levers when installing or removing a supervisor module. A module that is partially
seated in the backplane will not function correctly.
14