Sony POWER HD FX PDW-700 Operation Manual page 154

No. Page
13 CAM
CONFIG 2
14 PRESET
WHITE
15 WHITE
FILTER
154 Menu List
Item Settings
TEST SAW SAW/REC
SELECT
COLOR BAR ARIB/100%/
SELECT 75%/SMPTE
USER & ALL OFF/ON
ONLY
RM COMMON OFF/ON
MEMORY
RM REC START RM/CAM/
PARA
SHT DISP MODE SEC/DEG
RM F NO CTRL/RET
DISPLAY
COLOR TEMP Display
<P> reference color
temperature.
C TEMP BAL <P> (–99 to 99)
R GAIN <P> (–99 to 99)
G GAIN <P> (–99 to 99)
AWB ENABLE OFF/ON
<P>
ND FILTER OFF/ON
CTEMP
ND FLT CTEMP 3200K/4300K/
<1> 5600K/6300K
ND FLT CTEMP 3200K/4300K/
2-4 5600K/6300K
ELECTRICAL 3200K/4300K/
CC<A> 5600K/6300K
ELECTRICAL 3200K/4300K/
CC<B> 5600K/6300K
ELECTRICAL 3200K/4300K/
CC<C> 5600K/6300K/
-----
ELECTRICAL 3200K/4300K/
CC<D> 5600K/6300K/
-----
Description
Selects the test signal.
Selects the HD color bar type.
Show only USER menu in the top menu.
Selects whether or not to share settings for when a
remote control unit is connected and when the unit
is used alone.
When an RM remote control unit is connected,
selects which recording start/stop buttons are
enabled.
RM: remote control unit
CAM: camcorder
PARA: both
Selects shutter speed display (seconds or degrees).
Selects the method used to display IRIS F values
on the MSU-900 or another remote control unit.
CTRL: Display on the basis of control value from
the camera (normal display method).
RET: Display on the basis of position information
from the lens (same method as when AUTO
IRIS is enabled).
Sets the white balance preset value.
Finer setting when the desired color could not be
obtained with the COLOR TEMP <P> color
temperature setting.
Sets the R gain preset value.
Sets the G gain preset value.
When the WHITE BAL switch is set to PRST,
turns the function that enables execution of AWB
(auto white balance) on and off.
Turns on and off the function which assigns
electrical CC filters to neutral density (ND) filters.
Select the color temperatures when the electrical
CC filters are assigned to the ND filters.
For details, see "To change the color temperature
when the ND filter is switched" (page 58).
Select the color temperatures selected by electrical
CC filter switching, when the electrical CC filter
switching function is assigned to an ASSIGN
switch.
For details, see "To switch between electrical CC
filters with an ASSIGN switch" (page 59).