Table of Contents
Advertisement
X9 Evolution 125
The display provides 3 icons with the words:
- Oil
- Service
- Belt
- The "Oil" icon flashes when a distance of 1000 km has been covered, and then every 3000 km.
- The "Service" icon flashes for the first time at 1000 km or after 1 year. After that, every 6000 km or after 1 year.
- The "Belt" icon warns the rider about the need to replace the driving belt. It lights up every 12000 km
After the maintenance operations at the authorised workshop,
it is necessary to cancel the indication by the icon/s with the
"Reset" button located on the front of the vehicle under the fair-
ing.
The "Reset" button resets the distance covered, and, in the
case of the "Service" icon, also the year count. This count re-
mains active even if the battery is disconnected for short peri-
ods of time.
To reset an icon, press the "Reset" key for less than a second to select the icon preceding the one to be reset and then hold
the "Reset" key for at least 3 seconds so that the following is displayed:
- The desired icon selected lights up.
- The flashing of that icon confirms the reset.
For instance, to reset "Service" icon, select "Oil" and keep the "Reset" key pressed for at least 3 seconds. To reset "Oil", repeat
the procedure described selecting "Belt".
Care must be taken with this procedure since icon selection and reset are simultaneous operations (for this operation it is not
possible to view the desired function and reset in two different key strokes because, if you do so, the following icon could be
reset).
Data check function
Date and check function
Date should be adjusted out when delivering the vehicle to the customer. This is because the clock
activation starts the year count for the "Service" function. If the clock has been previously activated,
reset the "Oil", "Service" and "Belt" functions. The calendar is programmed from 2000 to 2050. For date
and time adjustment act on the "Clock" and "Set" buttons.
To guarantee vehicle safety, each time the key switch is set to "ON", there is an automatic checking of
all the indicators on the digital section.
The digital section provides also a functional checking of the 4 analogue instruments and of the turn
indicator control. To activate this checking, press and holed the "Clock" and "Set" buttons simultane-
ously and then set the key switch to "ON". Within 4 seconds max, the software version is displayed, the
gauges go to the end of scale and the turn indicators light up.
Electrical system
ELE SYS - 79
Advertisement
Table of Contents
