Table of Contents
Advertisement
Cooling system
Insert the drive on the guide plug on the support
base which forms part of the specific tool drw. No.
020440Y, being careful to check that the convex
part faces upwards.
- Insert the flywheel cover with bearings on the ap-
propriate tool.
- Insert the shaft together with the mechanical gas-
kets on the bearings.
- With the appropriate punch and socket, insert the
shaft in the bearings and the drive until the end of
stroke of the appropriate tool cannot be seen.
N.B. Centre the punch well on the rotor. Push the
shaft in and check that the wheel flywheel cover is
level. Failure to respect this procedure damages
the drive.
- Reassemble the rotor cover with a new O-Ring.
-Tighten the 3 fixing screws to the prescribed tor-
que:
Locking torque: 3 ÷ 4 Nm·
N.B. Do not lubricate the O-ring. Otherwise, this
will result in ring deformation.
- Check the water pump if noise in the bearings or liquid leaking from the drainage hole inside the cover
is detected.
COOL SYS - 192
X9 Evolution 125
Advertisement
Table of Contents
