Sony DVCAM DSR-PD100AP Operating Instructions Manual page 93

Using the memory card slot – introduction
When the PC card adaptor or PC card does not come out
Remove the battery before ejecting the PC card adaptor/PC card.
Connecting the PC card/parallel port adaptor (not supplied) with
your computer
To display images recorded on the "Memory Stick" or PC card on the computer monitor,
connect the PC card/parallel port adaptor with your computer.
Turn off your computer, and then connect the PC card/parallel port adaptor (not supplied)
with your computer as illustrated below.
Install the MSAC-PR1 device driver into your computer from CD-ROM supplied with the
MSAC-PR1. For details, refer to "READ ME" on the CD-ROM.
Printer cable
Power/access lamp
To eject the PC card/PC card adaptor
Press the eject button.
Notes on the connection
• Select the one from the two DIN connectors that matches the keyboard connector of the
computer, and use this connector to connect the computer.
• When connecting the PC card/parallel port adaptor (not supplied) and the keyboard, make
sure sizes of the DIN connector of the keyboard and power cord match, then use the
adaptor connector to connect.
• For notebook computers, there is no need to connect the keyboard.
Note on the power/access lamp
Do not insert/remove the PC card adaptor or "Memory Stick" when the power/access lamp
is flashing; otherwise data on the "Memory Stick" or PC card may become damaged.
to D-sub
25-pin
connector
Adaptor connector
DC jack
Computer
to keyboard
connector
Keyboard
93