Cut Recording - Sony DSR-200 Operating Instructions Manual

Cut recording

You can make a recording with a stop-motion animated effect using cut recording. To
create this effect, alternately move the subject a little and make a cut recording. Secure
the digital camcorder and use the Remote Commander for effective cut recording.
(1) While the digital camcorder is in Standby mode, open the cover, then press MENU
to display the menu in the viewfinder.
(2) Press or
(3) Press or
(4) Press MENU to erase the menu display.
(5) Press START/STOP on the digital camcorder or the Remote Commander to start
cut recording.
The digital camcorder records about 6 frames, then enters recording Standby mode.
(6) Move the subject, and repeat step 5.
1
MENU
D ZOOM OFF
MENU
ZEBRA
COMMANDER
BEEP
FRAME REC
INT REC
SLOW SHTR
[ MENU ] : END
To cancel cut recording
Set the FRAME REC mode to OFF in the menu system.
Notes on cut recording
• The portion immediately after cut recording is completed may be longer than four
frames.
• You cannot do cut recording with photo recording.
• The remaining tape indicator may not be accurate if you do cut recording repeatedly.
If you change the mode as follows, cut recording is cancelled
• Turn STANDBY down to LOCK.
• Set the POWER switch to OFF or CAMCORDER/VTR to VTR.
to select FRAME REC, then press EXECUTE.
to select ON, then press EXECUTE.
2
MENU
FRAME REC OFF
ON
[ MENU ] : END
3
MENU
D ZOOM
ZEBRA
COMMANDER
BEEP
FRAME REC ON
INT REC
SLOW SHTR
[ MENU ] : END
5
START/STOP
DSR-200 U/C 3-858-622-22(1). E
47