Continuous Recording On Previous Cut - Sony MSW-900P Operation Manual

3-2-7 Continuous Recording on Previous Cut

By assigning the RE-TAKE function to the ASSIGN 1 switch, you can
use the ASSIGN 1 switch to position the tape at the most recent cut,
clear it and record the new cut.
For detailed information, see "4-8-5 Assigning Functions to ASSIGN 1/2
3
Switches" on page 4-107.
Example: After recording cut 3, clearing cut 3 and recording cut 4 after
Continuous recording the new cut after the cut before the
most recent cut
In the above example, with the camcorder in the recording pause mode
after recording the cut 3, press the RET switch on the lens while holding
the ASSIGN 1 switch down.
The camcorder automatically positions the tape at the end point of cut 2
and turns in the recording pause mode.
Record cut 4. Cut 4 is recorded after cut 2.
Note
When the pictures consisting of cuts recorded using the RE-TAKE
function are played back by the VTR for studio, the CHANNEL
CONDITION indicator, which indicates the condition of the played
back signal of the VTR, may be lit in yellow for the first 2 seconds. To
avoid this, it is recommended that you make the first part of the cut (in
the above example, the cut 4) longer.
3-40
Chapter 3 Recording and Playback
Cut 1
Tape running direction
Cut 2
cut 2
Cut 3
Cut 4