Sony DSR-200 Operating Instructions Manual page 76

Audio dubbing
Recording
(1) Set the POWER switch to ON and then set CAMCORDER/VTR to VTR.
(2) Open the cover, press ·, then ) or 0, to search for the start and end points of
the recording.
(3) Press P at the start point of the recording.
(4) Press AUDIO DUB
(5) Adjust the recording volume.
(6) Press P.
Audio dubbing begins.
If you are using an stereo input, press P on the stereo at the same time.
2
REW PLAY FF
3,
PAUSE
6
To stop recording
Press π.
To pause recording
Press P. To start recording again, press P.
To adjust the volume
If you set REC LEVEL to AUTO, the volume is automatically adjusted.
To adjust the volume manually, set REC LEVEL to MANU, and turn the REC LEVEL
dials.
Note on audio dubbing
You cannot operate audio dubbing on DV-formatted tapes. Depending on signal
conditions, you may not be able to operate audio dubbing even on DVCAM-formatted
tapes.
76
.
REC LEVEL
Audio source
: Signal flow
4
AUDIO
DUB
DSR-200 U/C 3-858-622-22(1). E