Print Start Command - Toshiba B-SX600 Series Command Manual

7. PRINT START COMMAND

Format
Byte/bit 7 6
0
Header
1
2
Command identifier
3
4
Operation mode
5
6
to Reserved
9
10
Operation after printing
11
Explanation
• Operation mode is specified by the following bits:
15 14 13 12
Action
• The printer operates according to the Action bits. When the CT bit is "1", the trailing end of the printed
media is cut.
Action
1 Print
2 Feed or cut
3 Reverse feed
6 Change of cut instruction
7 Job completion action
Others Undefined
• If a cut operation has been specified, the boundary of the applicable page will be cut when it reaches
the cutter position.
• Since the image buffer is not cleared after a printing is completed, it is possible to reprint the same print
data without sending the data again.
• When the AB bit is "1", the printer feeds the page to be printed in the reverse direction from the tear-off
position so that the sensor can detect the sensor mark again, then feeds it to the home position. To
use this function, "No cut operation" and "No tear-off operation" must be specified.
• The operation after printing differs depending on the models.
5 4 3 2
11 10 9 8 7
Reserved Reserved
Operation
1 0
'/'
'T'
'S'
'P'
00h
00h
00h
00h
6 5 4 3 2
AB CT 0 0
- 14 -
B-SX600 Command Manual
Remarks
Equivalent to the argument "mode"
Equivalent to the argument "more"
1 0
0 0