HP StorageWorks NAS e7000 V2 Quick Start Manual page 24

Product Overview
4. This is an optional step. Install NIC teaming software and create fault
5. Connect the fiber channel cables to the storage switch or hub. If selective
6. Place the NAS device into an active directory or Windows NT 4.0 domain for
7. While the system is online, assign the LUNs to the first NAS device one at a
Note:
Cluster service is installed on at least one node and that node is online. This can be
accomplished through selective storage presentation, SAN switch zoning, or having
only one node online at all times.
8. Using Logical Disk Manager (LDM), write signatures to the disks, mark them
9. Use the cluster installation guide included in the Cluster Tab of the Web to
10. This is an optional step. Enable protocols such as NCP and/or AppleTalk as
24
WebUI to configure the HBA and corresponding pathing software. Additional
information about the SAN connection tool may be found in Chapter 4 of this
guide
tolerant or load balanced network ports. Follow the recommendations found
in this guide and in the administration guide.
storage presentation (SSP) is being used, the administrator will need to enable
the connections one at a time as the cables are connected. See the cluster setup
instructions included in Chapter 4 of this guide prior to enabling any of the
presented storage.
ease of manageability. This is required for clustered systems.
time so that they can be identified easily in Device Manager. See the
procedure in the storage management section of the administration guide.
Do not let both nodes access the shared storage devices at the same time until
as basic (dynamic disk are not supported in a cluster), create corresponding
partitions, assign drive letters, and format the drives. Mount points are not
supported in Microsoft clustering. See the LDM online help for full details on
this procedure.
configure the cluster. Cluster installation information is also included in
Chapter 4 of this guide and the cluster section of the administration guide.
Successful setup is dependent upon the use of the cluster checklist.
desired. See the administration guide for this procedure in detail. Certain
protocols are available for use in a cluster but are not cluster aware protocols :
NCP, AppleTalk and HTTP. See the administration guide for complete details.
NAS e7000 v2 Quick Start Guide