Swann SWWHD-DP890C Instruction Manual page 14

APPENDIX
Registering a doorbell
The supplied doorbell and handset units are pre-registered. If, for some reason, the doorbell is not registered to the
handset (you have reset the handset, for example), or if you have an additional doorbell to register, follow the steps
below:
Doorbell
1. Using a narrow tip (such as a small screwdriver), press the Register button in the battery compartment of the
doorbell for 3 seconds. The LED ring lights up and then blinks.
Handset
Within 60 seconds of pressing the Register button on the doorbell:
2. Press Menu to access the menu.
3. Press or to Register and press Select.
to select which number (1 or 2) you want to assign to the doorbell. Note: If the doorbell is an
4. Press or
additional unit, select "#2".
√
5. Press to begin the registration process. Once registration is successful, the doorbell beeps once and its LED
ring light turns solid then off. The handset exits the menu.
(Optional) Connecting an electric door strike
You can connect an electric door strike (sold separately) to the doorbell and unlock the door for your visitor using the
handset by pressing
Please see the manual that comes with your electric door strike for specific installation information such as the DC
power source required. Please note that this doorbell does not provide power to an electric door strike.
• Connect wires from your door strike to the "NC (normally close)" or "NO (normally open)" and COM holes on the
green terminal block in the doorbell. Refer to the terminal cover of the doorbell for the location of the "NC"/"NO"
(second/third from right) and "COM" (fourth from right) terminal holes.
14
. The following is general information on connecting an electric door strike to the doorbell.