Sony CINEALTA PDW-F330K Operating Instructions Manual page 48

2
Set the power switch of the WRR-855 to ON, and set
MUTING to ON or OFF.
This enables the WRR-855 power to be turned on and
off with the camcorder POWER switch.
3
Insert the WRR-855 into the CA-WR855.
4
Engage the V-shaped plate on the back of the
CA-WR855 with the V-groove on the battery
attachment shoe, and then slide the CA-WR855 down
until it connects to the WRR connector.
5
Set the AUDIO IN switch to WIRELESS (or W).
To attach a WRR-861/862 (When using a
BP-GL95/GL65/L60S/L80S Battery Pack)
1
Attach a WRR tuner fitting (not supplied, service part
number: A-8278-057-B) to the back of the camcorder.
1 Use a Phillips type screwdriver to tighten the four
screws placed in the tuner fitting as illustrated
below.
Note
Check that the four screws are firmly tightened.
48
Preparing the Audio Input System
WRR connector
Fasten the screws
(supplied with the WRR-855).
CA-WR855
2 Loosen the adjustment screws of the tuner fitting.
3 Adjust the tuner fitting position for a BP-GL95/
GL65/L60S/L80S Battery Pack to be attached, and
tighten the adjustment screws to fix its position.
4 Attach the mount plate supplied with the WRR-
861/862.
BP-GL95/GL65/L60S/L80S
Adjustment
screws
Back of the
camcorder
2
Attach the battery pack.
For details about attaching the battery pack, see
"Using a Battery Pack" on page 36.
3
Mount the tuner on the WRR tuner fitting.
For details about the WRR tuner fitting (service part
number: A-8278-057-B), contact your Sony dealer.
4
Connect the tuner power cord to the DC OUT
connector of the camcorder, and the audio output cable
to the AUDIO IN CH-1 or CH-2 connector.
5
Set the switches as follows.
• Set the AUDIO IN input selection switch to MIC for
the channel to which the audio output cable is
connected.
• Set the AUDIO IN (CH-1/CH-2/CH-3/CH-4) switch
for the channel to which the audio output cable is
connected to REAR (or R).
Mount plate (supplied
with WRR-861/862)
Phillips type screwdriver
WRR-861/862