Sony CINEALTA PDW-F330K Operating Instructions Manual page 26

1) Equipment that can be powered through i.LINK cable (DV cable)
e REMOTE connector (8-pin)
Connect an RM-B150/B750 Remote Control Unit, which
makes it possible to control the camcorder remotely.
Note
Before connecting/disconnecting the Remote Control Unit
to/from the camcorder, be sure to turn off the camcorder
POWER switch.
f DC OUT 12V (DC power output) connector (4-pin,
female)
Supplies power for a WRR-861/862 UHF Synthesized
Tuner (optional) (maximum 0.2 A).
Do not connect any equipment other than the UHF
synthesized tuner.
g TC (timecode) connector (BNC type) and IN/OUT
selector switch
F330
• IN/OUT selector switch: IN
To apply an external lock to the timecode, input the
reference timecode.
• IN/OUT selector switch: OUT
To lock the timecode of an external VTR to the timecode
of this unit, connect this connector to the external VTR's
timecode input connector.
h VIDEO OUT connector (BNC type)
F330
Outputs a video signal for a video monitor. When the
output signal is composite, setting menus, timecode, or
shot data can be superimposed on the camera output video
depending on the menu settings, and you can view them on
the monitor screen. To lock the timecode of an external
device to the timecode of this unit, connect the genlock
signal input connector of the external device to this
connector.
Note
The subcarrier phase cannot be adjusted.
i AUDIO OUT CH-1/CH-2 (audio output channel 1/
2) connectors (RCA phono jacks)
F330
Output the audio singnals being recorded or played back.
Connect to a stereo amplifier or video monitor's audio
input connectors.
26
Location and Function of Parts
j AUDIO OUT connector (XLR type, 5-pin, male)
F350
Output the audio signals recorded on audio channels 1 and
2 or audio channels 3 and 4. The audio signals are selected
by the MONITOR switch.
k HDSDI OUT connector (BNC type)
F350
Outputs an HDSDI signal (supporting the embedded audio
function).
Connect a video monitor with an HDSDI signal input
connector to check the video being shot by the camera.
You can also monitor VDR playback video.
Notes
• Even when you are recording or playing back HD
23.98P signals, 23.98PsF signals are not output from this
connector. The output is 59.94i signals after 2-3
pulldown.
• When the video recorded in the DVCAM format is
played back, no signal is output.