Sony Handycam CCD-TRV228E Operation Manual page 72

8
Press the SEL/PUSH EXEC dial.
The ending point of the first program is set,
and the lower part of the program mark
changes to light blue.
0 : 09 : 07 : 06
VIDEO EDIT
MARK 2 IN
UNDO
ERASE ALL
START
EDIT SET
TOTAL 0 : 00 : 12 : 00
SCENE 1
[ MENU ] : END
9
Repeat steps 5 to 8 and create
programs.
10
Set your VCR to the recording pause.
Skip this step if your camcorder is
connected via an i.LINK cable.
11
Turn the SEL/PUSH EXEC dial to
select [START], then press the dial.
0 : 09 : 07 : 06
VIDEO EDIT
MARK ENGAGE
UNDO REC PAUSE
ERASE ALL
START RETURN
EDIT SET EXECUTE
TOTAL 0 : 00 : 12 : 00
SCENE 1
[ MENU ] : END
12
Turn the SEL/PUSH EXEC dial to
select [EXECUTE], then press the dial.
A search for the beginning of the first
program starts, then the recording starts.
[SEARCH] appears during search and
[EDITING] appears during editing.
0 : 00 : 06 : 00
V I DEO ED I T
EDITING
SCENE 1 / 1
[ ] : CANCEL [ MENU ] : END
When a program is recorded, the program
mark stops flashing and remains lit. When
all programs have been recorded, the
program editing operation stops
automatically.
To cancel recording, press
72
Dubbing/Editing
To end Digital program editing
Press MENU.
To save a program without using it to
record
Press MENU in step 11.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 4 in "Recording the
selected scenes as programs" (p. 71).
2
Turn the SEL/PUSH EXEC dial to select
[UNDO] or [ERASE ALL], then press
the dial.
When you select [UNDO]
You can erase the last set program.
When you select [ERASE ALL]
You can erase all the programs.
3
Turn the SEL/PUSH EXEC dial to select
[EXECUTE], then press the dial.
The programs are deleted. To cancel this
operation, select [RETURN], and then
press the dial.
b Notes
• You cannot set starting point or ending point on a
blank section of the tape. If there is a blank section,
the total time may not appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 9 on
p. 69, and set the [IR SETUP] code.
(stop).