Checking The Recorded Picture - Sony CCD-TRV112 Operating Instructions (primary manual) Operating Instructions Manual

Checking the recorded picture

Using EDITSEARCH, you can review the last recorded scene or check the recorded
picture in the viewfinder. You can also review the picture on the LCD screen.
(1) While pressing the small green button on the POWER switch, set it to
CAMERA.
(2) Turn STANDBY up.
(3) Press the – (Œ) side of EDITSEARCH momentarily; the last few seconds of the
recorded portion plays back (Rec Review). You can also monitor the sound
from the speaker or by using an earphone (not supplied).
Hold down the – side of EDITSEARCH until the camcorder goes back to the scene you
want. The last recorded portion is played back. To go forward, hold down the + side
(Edit Search).
1
CAMERA
OFF
PLAYER
To stop playback
Release EDITSEARCH.
To go back to the last recorded point after edit search
Press END SEARCH. The last recorded point is played back for about 5 seconds if the
tape was recorded in SP mode, or 10 seconds if the tape was recorded in LP mode, and
stops.
Note that this function does not work once you eject the cassette after you recorded in
the tape.
To begin re-recording
Press START/STOP. Re-recording begins from the last recorded point or the point you
released EDITSEARCH. Provided you do not eject the tape, the transition between the
last scene you recorded and the next scene you record will be smooth.
2
Œ
CCD-TRV12/TRV22/TRV33/TRV112/TRV212 3-859-057-15.E
3
Œ
EDITSEARCH
Œ
15